www.kitcarecorp.com firstname.lastname@example.org 464 Call us today at 1-800-387-1858 or 416-243-3030 Anti-Slip Acrylic Paint Beige J2-97305 Handicap Blue J2-97306 Tile Red J2-97302 Gray J2-97301 Product Description • A tough, one part, anti slip coating suitable for a variety of interior and exterior applications. • No Skidding® Super Acrylic High Profile One Part also resists weathering, abrasion and mild chemicals. • Significantly reduces the chances of slipping, although this product cannot totally prevent the possibility of slipping. • Low odour and low VOC. • Soap & water cleanup. Recommended Uses • Suitable for use on walkways, steps, ramps, locker room floors, boat docks, around pools, steps, ramps, tennis courts and a variety of other interior and exterior concrete, wood and metal surfaces that have been properly prepared. Finish: T extured Flat Vehicle: Acrylic Resin Formulation: Lead, Chromate and Mercury free Physical Data Gloss Rating: Flat Viscosity: 125-130 K.U. Percent Solids: Weight: 63.9±2.0%, Volume: 45.7±2.0% Net Wt. Per Gal: 12.6±0.25 lbs/gal VOC Category: 2.1 lbs/gal (250 grams/litre) Flash Point: 158°F Closed Cup Surface Preparation & Application Instructions • All surfaces must be clean and free of dust, dirt, grease, mildew, soap residue, loose paint, glue size and any other foreign matter. For best results, the cause of any previous paint failure should be corrected before repainting. • Floor is dry to walk on after 24 hours under good drying conditions. • PressureTreated Wood:Power wash thoroughly to remove oils in the wood before application. • Apply with Low Pile Roller. Recommended Primers Metal: Anti Rust Metal Primers Galvanizing: Galvanized Metal Primer Masonry / Wood / Concrete & Weathered Asphalt: No primer required Application Temperature Minimum: 50°F Maximum: 90°F Drying Time (Good Conditions) Tack Free: 2 Hours To Recoat: 24 Hours Hard: 7 Days Practical Coverage 100-125 sq. ft./gal. (Depending upon the porosity of the substrate) Dilution Not normally recommended. If necessary, use small amounts of clean water. Recommended Film Thickness Per Coat Wet: 12.8-16.0 mils Dry: 5.0-8.0 mils *Clean up with soap and water Colors Available PLEASE READ AND FULL Y UNDERSTAND LABEL AND MSDS BEFORE USING. The most complete range of slip injury prevention products in the World. SUPER ACRYLIC HIGH PROFILE, SLIP RESISTANT WATER BASED Green J2-97313 Brown J2-97304 Y ellow J2-97308 Tintable White J2-97309 Black J2-97303 No Skidding® products are in use around the world in hotels, warehouses, factories, shopping malls, public transit systems, airports, hospitals and senior care, office complexes, restaurants, day care, schools, fitness clubs, government and military facilities. Important: Seller’s and manufacturers only obligation shall be to replace such quantity of the product proved to be defective. Neither seller nor manufacturer shall be liable for any injury, loss or damage, direct or consequential, arising out of the use of or the inability to use the product. Before using, user shall determine the suitability of the product for the intended use, and the user assumes all risk and liability whatsoever in connection therewith. No statement of recommendation not contained herein shall have any force or effect unless in an agreement signed by officers of the seller and manufacturer. Buyer assumes all risk and liability associated with disposal.